Hello to the Group, Does anyone have any information or a cutting chart for the following antenna? I have one and would like to put it into service on 10 meters. It was given to me without any info or radials. It is definitely used but appears to be intact. A quick web search turned up nothing.
Sticker Info on antenna: Antenna Specialists Dallas TX 75247-6780 ASPA 2010 30-40 MHz 9209508 Serial xxxxx-x It looks like a commercial version of a CB base antenna. The vertical radiator is a series of telescoping aluminum tubing pieces held in place with hose clamps. Maximum extended length of the vertical element is approximately 21 feet. Minimum contracted length is approximately 5 feet. The antenna uses 4 radials and the radial clamps appear to accept 5/16 inch rods. (I'm not sure if the radials are supposed to stick out straight or droop at some desired angle.) If nobody has any info, does the following tuneup procedure seem correct? 1. Cut a set of radials for 1/4 wL at 35 MHz. 2. Adjust the vertical radiator for best SWR within 30-40 MHz. 3. Measure and record vertical element, radial lengths, and frequency. 4. Scale recorded dimensions to the desired 10 meter frequency. Thanks and 73, Mark, N2MH