--- In Repeater-Builder@yahoogroups.com, "Joel" <[EMAIL PROTECTED]> wrote:
>
> --- In Repeater-Builder@yahoogroups.com, "skipp025" <skipp025@>
> wrote:
> >
> > Well...
> >
> > First:
> > If you have the original cable set and know the frequency of
> > design... might be prudent to replace them into service to see
> > if you can obtain the spec'd notch value.
> >
> > I did check these on the original freq and original factory
cables
> with same results
>
> > Second:
> > You might note the IFR 1600's generator output value and
> > crank it up min 10dB and better yet 20 dB. Then have a second
> > look...
>
> > Did that
> > Thanks Joel
> > cheers,
> > s.
> >
> > > Joel Hall <kj4si@> wrote:
> > >
> > > Hope some of you guys that have some experince with db 4060
> > duplexer,the pass is fine but the notch is the problem I can see
the
> > notch at around 35db on my ifr 1600s per each can but when i
combine
> > them together about 50db is the best i can get I have new cables
> made
> > 1/4 wave long , the tuning caps seem a little flakey may have
had
> been
> > hit with a lightning surge.
> > > I have not taken them apart yet so any thoughts?
> > >
> > > Thanks kj4si
> > >
> >
>
hi joie i would look at the tee conector that is where the problem
is i bet seeeya kb4ptj
