hey all, must be the season for truckload sales.
this time it's my own stuff.
i want to unload, er... sell, an OPERATIONAL repeater, irlp, simplex setup.
you'll be needing feedline and an antenna unless you want the quad-band
vertical from mfj.
ok, you can look over the pictures from the links below, i'll try to cover
it here in text.
top to bottom:
mastr exec II - this was a uhf combination but has 33 split rx and tx
modules.
crystalled and tuned to 53.45 tx and 51.75 rx (1.7 meg offset)
it has g.e. tone board (big red) in rx only mode on 146.2
better than .3uv rx from the hp 8924c. 42 watts out of the duplexer
cabinet.
squirrel cage blower on the heatsink fins with "circuit" connected
to the controller.
homebrew (by me) power supply - has run and will run 3 100 watt amplifiers
or rigs all day long.
it has been my primary supply for years. it has 3 35amp bridges and
is very heavy duty.
it used to run a 6m 100 watt amp, 70cm 100 watt amp, icom 746 @ 100
watts as remote base.
tone panel - NOT INCLUDED in sale
arcom rc210 repeater controller - this is fairly new. it's the latest
hardware version and running 4.74 firmware.
ibm thinkpad 760xl - programming the rc210. this DOES go but i've got to
take the hard drive or spend an hour "cleaning"
alinco dr-135t - hooked up to the rc210 on port 2. does a great job.
mini itx computer running centos irlp distro. node 3185. all passwords etc
etc passes to buyer.
master II 13 split rx drawer. NOT hooked up at present. but has been
checked out with said 8924c and works fine.
crystalled on 29.600 if i remember correctly. had been connected to
aux audio on the rc210.
db-4030 duplexer - coils clipped by me and tuned to repeater pair.
obviously this notch only 4 can setup doesn't provide desense free
isolation.
it does work very well @ the 1.7mHz split though.
sinclair q202g - this set is the higher split for vhf but tuned ok @
147.045+
1 can has been opened to reseat the plunger but the 8924c couldn't
tell.
never got a coordination so there it sits.
not in the pictures is a vhf mastr exec II desktop matching the 6m. it has
NOT been duplexed or recrystalled.
it has been benched and works fine on the stock crystals.
also, a uhf mastr exec II desktop that also works but doesn't have
the LED clock in it.
another vhf mastr exec II desktop. a 13 split mastr II mobile
a mastr exec II mobile i "think" a 33 split but could be an 88. i
didn't dig it out.
1 accessory group for an exec II mobile. 1 accessory group for a
mastr II mobile.
----
http://www.fidnet.com/~kb0wlf/repeater/1a.jpg
http://www.fidnet.com/~kb0wlf/repeater/2a.jpg
http://www.fidnet.com/~kb0wlf/repeater/3a.jpg
http://www.fidnet.com/~kb0wlf/repeater/4a.jpg
http://www.fidnet.com/~kb0wlf/repeater/5a.jpg
http://www.fidnet.com/~kb0wlf/repeater/6a.jpg
----
obviously this is a pickup and haul away kind of deal.
there are other things in the shack that could be negotiated but the above
is for sure going with the buyer.
i'm in Salem, Missouri.
that is 30 minutes south of Rolla, Missouri.
that is on i-44 halfway between sprinfield missouri and st. louis missouri.
i'd like 1000.00 u.s. cash on pickup.
i appreciate the bandwith and hope this pile can help someone or their club
out.
chris
kb0wlf
