AL_PA ? a new word for me :)

The only thing we did before adding a new server with HBA is creating a
soft zoning config to separate qlogic HBA from Emulex HBA.

I cannot see the wwn of the node on the switch gui
here is the portshow
tx again !

SANSWITCH1:admin> portshow 14
portName:
portHealth: No Fabric Watch License
Authentication: None
portDisableReason: None
portCFlags: 0x1
portFlags: 0x4001        PRESENT U_PORT LED
portType:  11.0
POD Port: Port is licensed
portState: 2    Offline 
portPhys:  5    No_Sync 
portScn:   2    Offline  
port generation number:    0
portId:    010e00
portIfId:    4302000e
portWwn:   20:0e:00:05:1e:02:8a:a3
portWwn of device(s) connected:
Distance:  normal
portSpeed: Negotiating
LE domain: 0
FC Fastwrite: OFF
Interrupts:        886377     Link_failure: 1085       Frjt:        
0         
Unknown:           0          Loss_of_sync: 3276       Fbsy:        
0         
Lli:               462653     Loss_of_sig:  3311      
Proc_rqrd:         0          Protocol_err: 0         
Timed_out:         0          Invalid_word: 257255    
Rx_flushed:        0          Invalid_crc:  0         
Tx_unavail:        0          Delim_err:    0         
Free_buffer:       0          Address_err:  0         
Overrun:           0          Lr_in:        0         
Suspended:         0          Lr_out:       0         
Parity_err:        0          Ols_in:       0         
2_parity_err:      0          Ols_out:      305       
CMI_bus_err:       0         
Port part of other ADs: No



Justin Cook wrote:
> It looks like you are having problems with your AL_PA addressing. What
> are you plugging this into, and how is that port configured?
>
> Your error message shows it is requesting an AL_PA and immediately
> returning an error.
>
> On Fri, Dec 5, 2008 at 4:00 PM, FM <[EMAIL PROTECTED]> wrote:
>   
>> Hello,
>> my FC switch cannot see the HBA connect to one of its port.
>>
>> hardware
>>  HP Proliant DL 385 G2
>> HBA : HP HPAE311A (Qlogic modele 2432) connected to a EVA 4000
>> Firmware of HBA : 4.03.02 [IP] [Multi-ID]
>> OS : Redhat : 5.2 64 bits
>>
>> modprobe load the qla module.
>>
>> But all lights are flashing on the HBA (seems to mean firware firmware
>> init) and logs keeps telling me :
>> Dec  5 10:39:17 imola kernel: qla2xxx 0000:0b:00.0: LIP occured (f8f7).
>> Dec  5 10:39:17 imola kernel: qla2xxx 0000:0b:00.0: LIP reset occured
>> (f7f7).
>>     
>
>
>   

_______________________________________________
rhelv5-list mailing list
[email protected]
https://www.redhat.com/mailman/listinfo/rhelv5-list

Reply via email to