Morning All, I have been doing more testing of Rev 119, Linux, using both ROS4.02 and 4.39. There seems to be some problems relating to modules. ROS4.39 reports "Soft-load driver not present" when I select the CD-ROM drive, but !Zap reports that all the same CDFS modules that are on my RISCPC are present. CDFSSoftATAPI and CDFSSoftCS12 are there. I have searched my RISCPC 4.39 !Boot and there are no CDFS modules loaded from there so all this stuff must be in the roms. Is it possible rpcemu isn't reading or using all the rom properly? I'm not sure if this is a related problem or not, but thought I would try !TechWriter. If I try to start !TW in rpcemu it complains that "File 'System:Modules.CallASWI' Not found", but when I copy that module from my 4.39 !Boot, reboot rpcemu (using 4.39 roms) and the start !TW it complains that "CallASWI module will only work on RISC OS 3.1, 3.5 or 3.6"...yet the same !TW works OK on my RPC with that module present. Am I missing something here or is likely to be another artifact of rpcemu being a bit wrong somewhere...not really knowing which version OS it is or somesuch?
Here are some lines out of the !TW run file, which probably have something to do with what is going on. I don't know what ProcMode does it is a Utility which is binary. ProcMode is probably not getting the right response from the OS. ------- run <Obey$Dir>.ProcMode TechWriter$32bitSystem If NOT <TechWriter$32bitSystem> Then RMEnsure CallASWI 0.03 RMLoad System:Modules.CallASWI If NOT <TechWriter$32bitSystem> Then RMEnsure CallASWI 0.03 Error This application requires CallASWI 0.03 or later -------- Hope these reports are helpful to someone. Cheers, -- Regards, Terry Duell _______________________________________________ Rpcemu mailing list [email protected] http://www.riscos.info/cgi-bin/mailman/listinfo/rpcemu
