Dear Rance, We got that set. The 1.5 was too small, the 2.0 was too large... Don
On Jan 24, 2012, at 11:43 AM, Rance Velapoldi wrote: > Hi Don: > MicroMark has them in a set of 8 with 0.5mm steps so that probably would be > ok. I guess I had better stick with the metric set, however, rather than the > inch ones. > thanks for info. > regards, > Rance > > On 1/24/2012 17:34, Don Thompson wrote: > >> >> Dear Rance, >> >> We had to special order nut drivers for the 2-8-0. They are 1.6mm and >> impossible to find in the US. We still have some if that will work, but I >> suspect they might be a bit larger. >> Don >> >> On Jan 24, 2012, at 11:05 AM, Rance Velapoldi wrote: >> >>> >>> Hi all: >>> One of the hex headed machine screws that holds the side/drive rods on >>> my AM 4-8-4 came loose. I looked for some nut drivers that I thought I >>> had, but couldn't find them at home (typical). I checked with Micro >>> Mark and they have a few sets sets, in metric and inch. Has anybody >>> used either of those and which would be better for the engine side >>> rods? I assume that the metric would be best since the engines are made >>> in China - however, maybe the manufacturers (AM, SHS, etc.) might make a >>> suggestion. Does anyone have any other suggestions besides MicroMark >>> where I can order them and have them sent to California??? >>> Thanks in advance for any advice. >>> Rance Velapoldi (Tranby, Norway) >>> ps Any suggestions for a loc tite material to hold machine screws in? >>> Might as well order both together. >> >> > > >
