(for comparison, previously installing dot2tex took just a few seconds) On Sunday, 12 October 2025 at 09:36:04 UTC+2 Martin R wrote:
> On Sunday, 12 October 2025 at 04:14:24 UTC+2 [email protected] wrote: > > it might take a lot of time to create the correct list of targets, as you > don't follow the best way, which is > > ./configure --enable-dot2tex=yes > make # this should also build do2tex > > > I thought that this would be the default (if installed, which it is): > > --enable-dot2tex={no|if_installed (default)|yes} > enable build and use of the optional package > dot2tex: Create PGF/TikZ > commands from Graphviz output > * package info: ./sage -info dot2tex > > I'll try anyway. But in fact, that also means that I have to be more > careful than previously, since there are several packages I only install > when I notice that something isn't working (eg., dot2tex, lie, coxeter3, > gap_packages, fricas, bliss, macaulay2 ...) > > > On Sat, Oct 11, 2025 at 6:12 PM Volker Braun <[email protected]> wrote: > > Does it actually hang there? the "meson setup" step takes quite a long > time but eventually completes for me > > > More than 3 minutes? If so, it would be nice if there could be some > progress output. > > I'll report, > > Martin > -- You received this message because you are subscribed to the Google Groups "sage-devel" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion visit https://groups.google.com/d/msgid/sage-devel/1ea2263f-37f2-4317-8f5d-1c3519609094n%40googlegroups.com.
