Title: Message
|
The
only reason I can tell that the installer wants a reboot is because it registers
the Servers Alive service every time it is installed. I have seen some
rare instances where the old version will restart after an upgrade unless the
system is rebooted.
Dirk,
is there a way in the installer to check for an existing Servers
Alive service? I set my services with recovery options and need to
reset them after every installation.
-Kevin
Why does Servers
Alive require a reboot after install? If the application has already
been installed, albeit a previous version, and is shutdown before the install
proceeds, why does it require a reboot? It seems to function correctly
without it.
-----Original
Message-----
From:
[EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Dirk Bulinckx
Sent: Wednesday, June 18, 2003 11:41
PM
To:
[EMAIL PROTECTED]
Subject:
RE: [SA-list] Alerts
already
in previous builds (for the HTML output):
dirk.
-----Original
Message-----
From:
[EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]On Behalf Of arley dealey
Sent: Thu Jun 19 3:42 AM
To: [EMAIL PROTECTED]
Subject: RE: [SA-list]
Alerts
I'll
definitely second this request. One of the few things I really want that I
haven't been able to devise a work-around.
>> Where do
you want to see this? HTML output? Mail?
Yes.
Both please. Actually, I want to be able to use it in any sort of alert
which SA can generate (this is a general answer to any piece of information
that I'd like to be able to report, it should always be available regardless
of the alert method).
-----Original
Message-----
From:
[EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]On Behalf Of Dirk
Bulinckx
Sent: Wednesday,
June 18, 2003 10:54 AM
To: [EMAIL PROTECTED]
Subject: RE: Alerts
Were
do you want to see this? HTML output?
Mail?
dirk.
-----Original
Message-----
From:
[EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]On Behalf Of Jason
Passow
Sent: Wed Jun 18
4:44 PM
To:
[EMAIL PROTECTED]
Subject: [SA-list]
Alerts
Is there a
variable to show me when last status change? In other wards, from 2am to
5am I do not want alerts however after that time I receive alerts
again. I am using the new “when a times down and every b
cycles” however I use %t %d variable but that only tells me the
time of the last check. I would like to know when the failure
started not the last time the failure occurred. In other wards I
want to know when it went from up to down or visa versa. If it is
not currently possible would it be possible to
implement?
Jason
Passow
[EMAIL PROTECTED]
PO BOX 1036
5150 West Sixth
St
Winona, MN
55987
|
