If you issue the following command [snmp-server ifindex persist] IOS from the config, you will have to lookup the CATOS equiv, the interfaces stay static. Even if you add remove cards it doesn't redo them for the current ones etc.
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Richard Temple Sent: Wednesday, July 27, 2005 4:55 AM To: salive@woodstone.nu Subject: RE: [SA-list] Monitor cisco interfaces yep, we use snmp to check the status of each serial interface. I used a program called getif to scan the MIB table of the router and found each OID entry that way (i think that is the correct terminology). One downside is that if you change or move the cards in the router, you have to redo all the checks as all the numbers change. -----Original Message----- From: [EMAIL PROTECTED] on behalf of Jason Passow Sent: Tue 26/07/2005 20:01 To: salive@woodstone.nu Subject: [SA-list] Monitor cisco interfaces I am sure many of you are already doing this so instead of reinventing the wheel. Can someone tell me what they are doing to monitor Cisco interface state? I imagine it is best to use snmp. Assuming that is correct does anyone know the ids or the easiest way to find them? -- Jason Passow Mississippi Welders Supply [EMAIL PROTECTED] ph: (507) 494-5178 fax: (507) 454-8104 ------------------------- [This E-mail scanned for viruses by Declude Virus] To unsubscribe from a list, send a mail message to [EMAIL PROTECTED] With the following in the body of the message: unsubscribe SAlive