It was a screw up! Stick the port externally on the rear slope - just above the vents
The disk drive was re-wired to be on the right hand side - and the printer i/f board was wired to the left hand space .... how did Adrian Parker describe it to me? Looks like an issue 1 Speccy inside ,.... with cables all over the place. ----- Original Message ----- From: Martin Wilson <[EMAIL PROTECTED]> To: <sam-users@nvg.ntnu.no> Sent: Sunday, August 22, 1999 12:24 PM Subject: Re: SAM COUPE PRINTER. > > > David L wrote: > > > > The mutant SAM - the Elite did have an Printer interface built in. > > > > Malcolm's machcine had his Mouse i/f built into thecase - and I know a few > > others who either had this or the Printer i/f built in. > > > > The planned SAM Pro - kicked around a couple of months before SAM Co went > > down by Adrian Parker & Alan Miles would have had this, the Kaliedescope, > > and a few other neat ideas built in.... but thats another story! > > > > I never say a Elite in the flesh. What did it look like? Was the printer > interface nicely done? Was it still bbc type or did they just screw on a > pc type connector? Were any other ports removed to make room? > >