> From: Ian Dalziel [SMTP:[EMAIL PROTECTED]
>
>> TV modulator don't work correctly.
>> So, I must try connect SAM and TV without modulator direct via SCART
>> connector.
>>
>> But, I don't know how?
>> Exist somewhere on web circuit diagram for SAM_SCART & TV_SCART cable.
>>
>
>Standard SCART cable, AFAIK - has to be fully connected, is all
>
>
>Ian Dalziel
That is incorrect... There are some wires that are incompatible between the
SAM and the SCART standard.
Aley Keprt once sent an email to the list with the following:
-- quoted text --
Well, here comes the describtion of scart-to-scart cable, which can be used
to connect Sam to TV, VCR or satellite.
out: 1,4,3,19,21
in: 2,4,6,20,21
Remember to connect pin 21 as screen.
Simply connect the specified pins (IN THAT ORDER!).
Then connect "out" side to Sam, and "in" side to TV/VCR/Sat.
(VCR means Video Cassette Recorder.)
Use a standard audio i/o cable (stereo input+output+screen = 4 wires +
screen).
This cable as well as two scart connectors should be available everywhere.
That's all.
If you wish you can also make the RGB cable, as described in the original
Sam's manual (at the end of that nice Basic describing book).
In that case use cable with 8 wires + screen.
Note that RGB cable can be used only for TV's which supports RGB!
You should read the manual of that TV before making RGB cable.
----------------------------------------------------------------
Aley [eili] Keprt - student, programmer (multimedia soft. etc.)
phone: +420-68-538 70 35
e-mail: [EMAIL PROTECTED] *** http://get.to/aley
----------------------------------------------------------------
-- end quoted text --
Hope this helps,
Justin
