Hi Leonardo,
Basically, you're answering your own question: the provider lets you
download a file that disables your service.
Normally, this file specifies the Class Of Service you get from your
provider, like upstream and downstream bandwidth.
Now for some reason, the provider doesn't want to
A route with origin egp is not learned from an external BGP peer, but from a
peer running the protocol EGP (External Gateway Protocol, the predecessor of
BGP).
It's also possible to change this origin code via a route-map.
Peter
-Original Message-
From: cebuano [mailto:[EMAIL
So if you have a router with S0 to the outside and e0 to the inside.
Suppose you have an inside network of 10.10.10.0/24, where 10.10.10.30 is
your webserver.
Suppose the IP addres of S0 is 172.16.0.1
ip nat inside source list 2 interface serial 0 overload
ip nat inside source static tcp
If you copied you running config to startup config then there shouldn't be a
problem.
Set the confreg to 0x2142, which causes the router to startup without
getting its config.
When it's back up, go into enable mode. There isn't a password obviously.
Then do a copy start run, and change the
Barry,
You can enable a trunk on the 3548, and create subinterfaces on the 3550 at
site A.
I don't know the exact configuration details about a 3550, but it should be
something like:
interface gigabitethernet 0/2
no switchport
!
interface gigabitethernet 0/2.10
encapsulation dot1q 10
10 seconds? That almost sound like the keepalive time setting.
After the no shut, the router tried to bring the interface up, sending a
keepalive to the other side, but it didn't receive anything back so it
brought the interface down again.
You may want to check the way you are receiving you're
-Original Message-
From: Barbu Alexandru [mailto:nastybruno;yahoo.com]
Sent: Friday, October 25, 2002 11:40 AM
To: [EMAIL PROTECTED]
Subject: cable network [7:56267]
Hi guys! I have a probem with some cable modems.
The fact is that in the network there are around 150
cable
you may want to have a look at:
http://www.cisco.com/en/US/tech/tk389/tk214/technologies_tech_note09186a0080
093dcb.shtml
Good luck!
-Original Message-
From: Sim, CT (Chee Tong) [mailto:[EMAIL PROTECTED]]
Sent: Monday, October 14, 2002 1:13 PM
To: [EMAIL PROTECTED]
Subject: what is
Some documentation may say that it's connection oriented because you have to
set up a PVC (or an SVC) so you pre-establish a connection.
But in fact it's connectionless, since it doesn't have, like you say, a
retransmission system or error checking mechanism
like TCP.
And the terms connection
Thinking of the subject again, I would have to come back to what I've said
before.
TCP is connection oriented because there's the three-way handshake session
establishment. It's reliable because of the retransmission and error
checking mechanismns.
UDP is connectionless, because there's no
10 matches
Mail list logo
