From the manual:
If you do have a KAT3 installed, you can connect antennas to both ANT1 and
ANT2; tap ANT to select. Holding ATU selects AUTO (autotune enabled) or
BYPASS mode. In AUTO mode (ATU icon on), the antenna can be matched for best
SWR by tapping ATU TUNE . Up to 30 ATU settings are
Run through the wattmeter and TX gain calibration steps and try again. I had
this same problem.
-Original Message-
From: Bill Thompson
Sent: Thursday, November 10, 2011 9:54 AM
To: elecraft@mailman.qth.net
Subject: [Elecraft] K3 Transmitter
My K3 is not transmitting. When I try to
If you have an external wattmeter (a lot of antenna tuners/dummy loads
should have this), then go through the wattmeter calibrations to ensure your
internal wattmeter is reading correctly.
-Original Message-
From: n2...@aol.com
Sent: Friday, October 21, 2011 7:54 PM
To:
Hello everyone,
I’m a newer K3 owner and I’m loving the heck out of the device, but recently I
noticed a strange problem. It started behaving as though my MIC wasn’t working
correctly.
[All tests from this point out will be into a DUMMY LOAD that is rated up to
300W.]
I would notice that
Thank you everyone for your replies. Gary from Elecraft was awesome to
chime in... He had me check a number of things, but I think the core problem
was the wattmeter needed to be calibrated.
Disconnect any RS232 connection and PC software control.
Redo the WMTR menu calibration.
When in WMTR
5 matches
Mail list logo