Shouldn't affect it in the classical BGP active./backup sense; only 1 'vrf' is
active in a multi-homing BGP setup.
However, since the SRX/J doesn't do that, both will end up being active -
You'll need a way to suppress one of them from getting any traffic. Perhaps
think about using an EX4200 u
Your'e right of course :)
My question was more how the VPLS multihoming will affect this setup.
Regards
Johan
On Thu, Aug 23, 2012 at 11:21 AM, Chris Kawchuk wrote:
> Err VPLS Implies Layer 2 only.
>
> Where is the VRP runninng in-between? Are you doing "vlan-id" inside the
> VPLS instance for
Err VPLS Implies Layer 2 only.
Where is the VRP runninng in-between? Are you doing "vlan-id" inside the VPLS
instance for normalization, then binding an irb.x into it? I dont think that
works in SRX/J either. (l3 within VPLS).
- CK.
On 2012-08-23, at 6:39 PM, Johan Borch wrote:
> "VPLS multi
I saw the following exceptions for SRX-series:
"VPLS multihoming, which allows connecting a CE device to multiple PE
routers to provide redundant connectivity, is not supported on J Series or
SRX Series devices"
I'm going to have two SRX's on each site and using vrrp between them, will
I hit this
Johan,
You might want to know that VRRPv6 isn't supported on the branch SRX so if you
need IPv6 resiliency, you're out of luck.
If you need both v4 and v6 node resiliency, the only way to do it now is
clustering which is a whole different beast altogether.
On Aug 15, 2012, at 10:29 PM, Johan B
On 15/08/12 16:50, GIULIANO (WZTECH) wrote:
Phill,
Could ou please share some juniper links or configurations on how about
to configure SRX boxes with MPLS in a RING topology ?
Sure.
I'm assuming you have a basic Juniper layer3 provider core configured.
In particular, you'll want an IGP (OSP
Phill,
Could ou please share some juniper links or configurations on how about
to configure SRX boxes with MPLS in a RING topology ?
Are you using L3 MPLS VPN or L2 VPLS or EoMPLS ?
Is it possible to share some configurations or links ?
Thanks a lot,
Giuliano
On 15/08/12 15:29, Johan Bor
On 15/08/12 15:29, Johan Borch wrote:
Hi,
I have a design question regarding MPLS.
I'm planning to create a MPLS rings with 4-8 SRX240 devices in packet mode
and the main purpose is L3VPN/VPLS
p1-p2-p3-p4-p5-p1 (p5 connects back to p1)
My budget is low for this and the srx240 is cheap, we wil
Hi,
I have a design question regarding MPLS.
I'm planning to create a MPLS rings with 4-8 SRX240 devices in packet mode
and the main purpose is L3VPN/VPLS
p1-p2-p3-p4-p5-p1 (p5 connects back to p1)
My budget is low for this and the srx240 is cheap, we will push max 1Gbps.
For example in some s
9 matches
Mail list logo
