The connectors and cable sold by Dymond are very well priced. The
connectors appear to be the same as those offered by Custom Electronics. I
have used connectors from both sources successfully.
Fred
-Original Message-
From: Kevin Sheen [mailto:[EMAIL PROTECTED]]
Sent: Sunday, December 08,
About a week ago during a discussion on the RCSE regarding a new TD task
involving hi-starts, I was asked to debrief the contest. If nothing else,
I'm a man of my word so the following applies:
The specifications of the hi-start were determined after extensive testing
and were finalized with t
No can do Perry...You can run a Hitec PPM Rx from your tranny but I'm pretty
sure that you cannot run the PCM.
-Original Message-
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]
Sent: Sunday, December 08, 2002 10:28 AM
To: [EMAIL PROTECTED]
Subject: [RCSE] HiTec/ Futaba
I have a Hi
Sounds like it's time for a stakeout...surely with a track record like that,
the police could be convinced to watch a vehicle in the parking lot stocked
with bait.
Tom
- Original Message -
From: GHANSON
To: soaring BBS
Sent: Sunday, December 08, 2002 5:41 PM
Subject: [RCSE] hotels for
I just got spammed by the guy from FVK models
Whats the world coming to?
Mark Mech
www.aerofoam.com
RCSE-List facilities provided by Model Airplane News. Send "subscribe" and
"unsubscribe" requests to [EMAIL PROTECTED] Please note that subscribe and
unsubscribe messages must be sent in tex
This attached message is being posted on behalf of
Byron Blakeslee. This particular Days Inn is right off US Hwy 60 in Mesa
at the SE corner of Country Club/Juanita.
FYI, four pilots have experienced thievery over the
last two straight years at hotels in the Mesa/Chandler/Gilbert area.
W
Let me clarify, I have a 10s not X for sale asking $300.00 plus shipping. Thanks--Glenn W.Tri-Cities, WaDo you Yahoo!?
Yahoo! Mail Plus - Powerful. Affordable. Sign up now
Martin,
check out:
http://www.ncws.com/rcrock/connector.htm
It should help,
Kevin
At 04:01 PM 12/8/2002 -0800, Martin Cleary wrote:
>I'm a bit frustrated with the cost of wiring components via the local
>dealer. I can appreciate the cost involved in a slow moving inventory...but
>$6 for a 6 i
Try Dymond out of Oshkosh. He has pigtails, raw connectors and extensions.
The extensions seem to be the better deal, cut 'em in half = 2 pigtails.
Much easier to solder the wire sections than to diddle around with the
connector pins. They are on the net at http://rc-dymond.com/
Be careful with
I'm a bit frustrated with the cost of wiring components via the local
dealer. I can appreciate the cost involved in a slow moving inventory...but
$6 for a 6 inch servo extension...
I'd like to make my own wiring harnesses. Is there a good source for bulk
connectors and the proper wire? Also, doe
HiTec makes PCM? I've only seen PPM aka FM from HiTec. Your Futaba will
run the HiTec FM receivers. PCM receivers require you to use RX's from the
same mfg. as the TX because all the PCM techniques are unique.
Kerry
I have a Hi Tec PCM receiver and an 8U tranny. Shouldn't it work with my 8u
11 matches
Mail list logo