RE: [Asterisk-Users] Problem with Sangoma/Adtran 600 installation
-Original Message- From: [EMAIL PROTECTED] [mailto:asterisk-users- [EMAIL PROTECTED] On Behalf Of Chris Mason (Lists) Sent: Saturday, April 30, 2005 5:59 PM To: 'Asterisk Users Mailing List - Non-Commercial Discussion' Subject: [Asterisk-Users] Problem with Sangoma/Adtran 600 installation I have installed Asterisk on a CentOS4 box and then installed Asterisk from CVS. [EMAIL PROTECTED] asterisk]# ztcfg Notice: Configuration file is /etc/zaptel.conf line 0: Unable to open master device '/dev/zap/ctl' 1 error(s) detected When I run service zaptel restart I get: Waiting for zap to come online...Error: missing /dev/zap! Wha am I doing wrong? [Reid Forrest] Check out README.udev in the zaptel source directory. You need to make modifications to the udev config files. ___ Asterisk-Users mailing list Asterisk-Users@lists.digium.com http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
RE: [Asterisk-Users] Problem with Sangoma/Adtran 600 installation
Thanks for the advice. That was part of the problem, but also the Sangoma stuff required I removed the modules from /etc/modules.conf and I had to configure the DSO mapping in the channel bank, which I knew nothing about. The Sangoma T1 card and the Adtran Channel Bank now work very well together, the only outstanding issue is CallerID on the FXO ports, I have to upgrade the firmware to support it. Chris Mason www.anguillaguide.com Tel: (305) 704-7249 Fax: (815)301-9759 ___ Asterisk-Users mailing list Asterisk-Users@lists.digium.com http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
RE: [Asterisk-Users] Problem with Sangoma/Adtran 600 installation
Also, what version of the wanroute driver software are you using? wanpipe-2.3.2-1 1. modprobe zaptel Works. [EMAIL PROTECTED] asterisk]# service zaptel start Loading zaptel framework: [ OK ] Waiting for zap to come online...Error: missing /dev/zap! Chris Mason www.anguillaguide.com ___ Asterisk-Users mailing list Asterisk-Users@lists.digium.com http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
Re: [Asterisk-Users] Problem with Sangoma/Adtran 600 installation
On May 1, 2005 08:36 am, Chris Mason (Lists) wrote: Waiting for zap to come online...Error: missing /dev/zap! Uh... the error seems obvious. Have a good look at the various READMEs in the zaptel source directory. -A. ___ Asterisk-Users mailing list Asterisk-Users@lists.digium.com http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
RE: [Asterisk-Users] Problem with Sangoma/Adtran 600 installation
I made some progres on this. The udev issues were causing me problems. I rectified this and was able to build zaptel successfully. Wanrouter start works great. [EMAIL PROTECTED] asterisk]# wanrouter start Starting WAN Router... Loading WAN drivers: wanpipe done. Starting up device: wanpipe1 Configuring interfaces: w1g1 done. The next problem comes here [EMAIL PROTECTED] asterisk]# ztcfg -v Zaptel Configuration == SPAN 1: ESF/B8ZS Build-out: 0 db (CSU)/0-133 feet (DSX-1) 24 channels configured. ZT_SPANCONFIG failed on span 1: Invalid argument (22) Chris Mason www.anguillaguide.com ___ Asterisk-Users mailing list Asterisk-Users@lists.digium.com http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
RE: [Asterisk-Users] Problem with Sangoma/Adtran 600 installation
x lk x x x Interface Name- w1g1x x x x Operation Mode- TDM_VOICE x x x x TDM Voice Span- 1 x x x x Override Asterisk Echo Enable - No What should the TDM Voice Span be? Chris Mason www.anguillaguide.com ___ Asterisk-Users mailing list Asterisk-Users@lists.digium.com http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
Re: [Asterisk-Users] Problem with Sangoma/Adtran 600 installation
the same you want it to be linked to in zaptel.conf so if you config it as span1 in zaptel.conf it has to say 1 On 5/1/05, Chris Mason (Lists) [EMAIL PROTECTED] wrote: x lk x x x Interface Name- w1g1x x x x Operation Mode- TDM_VOICE x x x x TDM Voice Span- 1 x x x x Override Asterisk Echo Enable - No What should the TDM Voice Span be? Chris Mason www.anguillaguide.com ___ Asterisk-Users mailing list Asterisk-Users@lists.digium.com http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users -- Michal Bielicki http://www.aefirion.org/ http://www.asterisk.com.pl/ ___ Asterisk-Users mailing list Asterisk-Users@lists.digium.com http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
[Asterisk-Users] Problem with Sangoma/Adtran 600 installation
I have installed Asterisk on a CentOS4 box and then installed Asterisk from CVS. I installed a Sangoma A101 and connected it to a Adtran 600 using a T1 Crossover cable. The 600 has 12 x FXS, 12 x FXO interfaces. I ran through the wanpipe install instructions and configured it, now I can run [EMAIL PROTECTED] asterisk]# wanrouter hwprobe --- | Wanpipe Hardware Probe Info | --- 1 . AFT-A101u : SLOT=1 : BUS=1 : IRQ=209 : CPU=A : PORT=PRI Card Cnt: S508=0 S514X=0 S518=0 A101-2=1 A104=0 A300=0 So I know the card is there OK. My /etc/zaptel.conf looks like: span=1,1,0,esf,b8zs loadzone = us defaultzone=us fxsls=1-12 I am only trying to get half to load for now to make it simple. [EMAIL PROTECTED] asterisk]# ztcfg Notice: Configuration file is /etc/zaptel.conf line 0: Unable to open master device '/dev/zap/ctl' 1 error(s) detected When I run service zaptel restart I get: Waiting for zap to come online...Error: missing /dev/zap! Wha am I doing wrong? Chris Mason NetConcepts (264) 497-5670 Fax: (264) 497-8463 Int: (646)722-0001 Fax: (815)301-9759 (305) 704-7249 Yahoo IM: [EMAIL PROTECTED] Skype ID: netconcepts ___ Asterisk-Users mailing list Asterisk-Users@lists.digium.com http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
RE: [Asterisk-Users] Problem with Sangoma/Adtran 600 installation
Hello, is this how you are starting up: 1. modprobe zaptel 2. wanrouter start 3. ztcfg -v 4. asterisk -vvvgc Also, what version of the wanroute driver software are you using? MATT--- -Original Message- From: Chris Mason (Lists) [mailto:[EMAIL PROTECTED] Sent: Saturday, April 30, 2005 5:59 PM To: 'Asterisk Users Mailing List - Non-Commercial Discussion' Subject: [Asterisk-Users] Problem with Sangoma/Adtran 600 installation I have installed Asterisk on a CentOS4 box and then installed Asterisk from CVS. I installed a Sangoma A101 and connected it to a Adtran 600 using a T1 Crossover cable. The 600 has 12 x FXS, 12 x FXO interfaces. I ran through the wanpipe install instructions and configured it, now I can run [EMAIL PROTECTED] asterisk]# wanrouter hwprobe --- | Wanpipe Hardware Probe Info | --- 1 . AFT-A101u : SLOT=1 : BUS=1 : IRQ=209 : CPU=A : PORT=PRI Card Cnt: S508=0 S514X=0 S518=0 A101-2=1 A104=0 A300=0 So I know the card is there OK. My /etc/zaptel.conf looks like: span=1,1,0,esf,b8zs loadzone = us defaultzone=us fxsls=1-12 I am only trying to get half to load for now to make it simple. [EMAIL PROTECTED] asterisk]# ztcfg Notice: Configuration file is /etc/zaptel.conf line 0: Unable to open master device '/dev/zap/ctl' 1 error(s) detected When I run service zaptel restart I get: Waiting for zap to come online...Error: missing /dev/zap! Wha am I doing wrong? Chris Mason NetConcepts (264) 497-5670 Fax: (264) 497-8463 Int: (646)722-0001 Fax: (815)301-9759 (305) 704-7249 Yahoo IM: [EMAIL PROTECTED] Skype ID: netconcepts ___ Asterisk-Users mailing list Asterisk-Users@lists.digium.com http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users ___ Asterisk-Users mailing list Asterisk-Users@lists.digium.com http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
