[Emc-users] Chip Load for Drilling
Here is the link for the chipload drilling article. Took me a while to find it... http://www.practicalmachinist.com/vb/showthread.php?p=862651#post862651 Enjoy John - Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace___ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
Re: [Emc-users] Chip Load for Drilling
On Thursday 27 March 2008, John Thornton wrote: Here is the link for the chipload drilling article. Took me a while to find it... http://www.practicalmachinist.com/vb/showthread.php?p=862651#post862651 Enjoy John Thanks, John. I could have used that today, I broke a 0.050 bit in cast iron, about 1/4 down on the second peck by mouse control, another .3 to go. I wound up moving the hole, but not quite far enough dinged up a 1/4-28 tap on the remains. Using a properly programmed peck cycle, I imagine I can do the next one just fine by following that advice. I was installing a grease fitting, and that was the channel into the bearing bore. I got all the parts to put ball bearing thrust washers in the screw bearings of my micromill today, so I ran out and put in the first pair. Sweet! No more squalling screws the backlash is now .0004! I can't wait to get the other axis done, but this cold rain ran me out of the shop till it warms a bit again. -- Cheers, Gene There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order. -Ed Howdershelt (Author) ... I see TOILET SEATS ... - Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace ___ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
Re: [Emc-users] Chip Load for Drilling
On Thu, Mar 27, 2008 at 05:42:24PM -0600, John Thornton wrote: Here is the link for the chipload drilling article. Took me a while to find it... http://www.practicalmachinist.com/vb/showthread.php?p=862651#post862651 John, Interesting thread, especially KAwhoom-FLAP!, but scrolling up down several times didn't reveal anything I could recognise as an article or link thereto. Is the chat in the thread the article, or did I blink? It seemed a good deal more flamboyant than recent informative description of experience with hard and soft aluminium, on this list, I thought. Erik - Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace ___ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users