We are seeing the message " PRI Error on span 1: Received MDL/TEI management
message, but configured for mode other than PTMP" on one of our Asterisk boxes
on a PRI. A Google search turns up a number of hits for this error, but they
are all for BRI not PRI.
I'm reasonably sure there are no re
MDL/TEI is pretty low level.
Which card are you using?
chan_dahdi.conf?
Card config?
PCAP trace? Q.931 and Q.921 messages are relatively easy to debug with
wireshark.
jg
--
_
-- Bandwidth and Colocation Provided by http://w
s-boun...@lists.digium.com
[mailto:asterisk-users-boun...@lists.digium.com] On Behalf Of jg
Sent: Tuesday, February 18, 2014 3:12 PM
To: Asterisk Users Mailing List - Non-Commercial Discussion
Subject: Re: [asterisk-users] PRI Error on span 1: Received MDL/TEI management
message, but configured for mode other tha
7(Multi-frame established)
> TEI=0 Got SABME from network peer.
> TEI=0 Sending UA
> TEI=0 MDL-ERROR (F): SABME in state 7(Multi-frame established)
>
> -Original Message-----
> From: asterisk-users-boun...@lists.digium.com [mailto:
> asterisk-users-boun...@lists.digium.com] On Be
Wieling
Sent: Tuesday, February 18, 2014 3:34 PM
To: Asterisk Users Mailing List - Non-Commercial Discussion
Subject: Re: [asterisk-users] PRI Error on span 1: Received MDL/TEI management
message, but configured for mode other than PTMP
I was not aware Wireshark worked on PRI spans. What interface
Mailing List - Non-Commercial Discussion
Subject: Re: [asterisk-users] PRI Error on span 1: Received MDL/TEI management
message, but configured for mode other than PTMP
Hi,
http://wiki.sangoma.com/wanpipe-wireshark-pcap-pri-bri-wan-t1-e1-tracing
On 18 February 2014 21:34, Eric Wieling wrote
Eric,
since you seem to have a Sangoma card, you should contact Sangoma's excellent technical support.
I'll have a look at your pcap trace tomorrow. You can also download the relevant Q.931 and Q.921
docs from ITU's web server.
Sangoma's wanpipe drivers allow you to configure a few hardware t
s Mailing List - Non-Commercial Discussion
Subject: Re: [asterisk-users] PRI Error on span 1: Received MDL/TEI management
message, but configured for mode other than PTMP
Eric,
since you seem to have a Sangoma card, you should contact Sangoma's excellent
technical support.
I'll
It seems a layer 2 problem, should check about references point (network or
terminal equipment), it assume your Asterisk box is connected to ISDN PSTN
provided, just in case check at you side if all related configuration files
are configured as signalling=pri_cpe (Card config, wan_cfg, chan_da
Eric!
The pcap trace seems to contain only idle data, and there is nothing unusual.
As far as I know, PRI always uses the static TEI value of 0, as there is only a single
"terminal equipment (TE). The TEI assignment procedure is only relevant if there is a BRI
connection on a so called "S0
-Commercial Discussion
Subject: Re: [asterisk-users] PRI Error on span 1: Received MDL/TEI management
message, but configured for mode other than PTMP
Eric!
The pcap trace seems to contain only idle data, and there is nothing unusual.
As far as I know, PRI always uses the static TEI value of 0, as
11 matches
Mail list logo
