Many Thanks Gerald, I got response to my RMA request this time. In fact I
received response to all my earlier RMA request as well.
Cheers
Mahesh
On Tuesday, October 27, 2015 at 7:37:52 PM UTC+5:30, Gerald wrote:
>
> Try the RMA again.
>
> Gerald
>
>
> On Tue, Oct 27, 2015 at 6:51 AM, mahesh
Hi,
I Also have exactly same behavior with my Rev C BBB.
@Gerald: I tried RMA twice but i did not got any response !! I got the
Board from Sumeet Online shop which is listed on beagleboard.org for Indian
buyers. Any thoughts?
Thanks & Regards
Mahesh
On Wednesday, November 5, 2014 at
Try the RMA again.
Gerald
On Tue, Oct 27, 2015 at 6:51 AM, mahesh ingle wrote:
> Hi,
>
> I Also have exactly same behavior with my Rev C BBB.
>
> @Gerald: I tried RMA twice but i did not got any response !! I got the
> Board from Sumeet Online shop which is listed on
Hi,
There should be a short on board. The U2 shuts itself down to prevent the
high current draw which is caused by the short. That is why the LED goes
off after it blinks once.
Regards,
Shu
On Monday, October 27, 2014 10:56:34 PM UTC-5, s...@kopi-d.com wrote:
I am in the same situation.
I am in the same situation. Was trying out new images. Did an forced SD
change to a non-bootable bbb. Now it won't boot. Just a pwr blink then
dead.
Are there any other ways to recover other than RMA? PMIC replacement or
reflashing of bootloader?
Sam
On Wednesday, June 18, 2014 9:53:25
RMA is the only way.
I suggest you request an RMA.
Gerald
On Mon, Oct 27, 2014 at 10:56 PM, s...@kopi-d.com wrote:
I am in the same situation. Was trying out new images. Did an forced SD
change to a non-bootable bbb. Now it won't boot. Just a pwr blink then
dead.
Are there any other
Request an RMA.
http://beagleboard.org/Support/RMA
And read this. http://www.elinux.org/Beagleboard:BeagleBoneBlack#Hardware
Gerald
On Mon, Jun 9, 2014 at 5:54 PM, v...@victor.so wrote:
My BBB (A5A) was working fine with ARM Arch (installed on the eMMC), but
since yesterday it won't turn
My BBB (A5A) was working fine with ARM Arch (installed on the eMMC), but
since yesterday it won't turn on. I don't know what changed.
When I plug the power source or the USB cable the PWR Led quickly blinks,
but the board doesn't turn on.
If I press the POWER button, the PWR led does a single