hi folks,
as everyone suggesting that one should be familiar with cli command for cue
setup and apparently i am following the same path suggested by experts... i did
ccn trigger, ccn application etc and when i look into cucm the cti rp and
cti ports were never registered, and so i went
I always went GUI exclusively. IMO, you don't need to do it via CLI.
DQ
d...@cisco.commailto:d...@cisco.com
Sent from my iPhone
On Aug 22, 2012, at 10:27 PM, Krishna
vinayak_...@yahoo.commailto:vinayak_...@yahoo.com wrote:
hi folks,
as everyone suggesting that one should be familiar with cli
After the reload , it takes sometime to get registered . You may see a crash
error and then it boots again and get itself registered with CUCM.
1) Start your configuration with a factory restore. 2) Just be sure that you
have same jtapi password on both ends.2) wait for a while before it get