At 04:15 PM 12/18/2003 -0500, you wrote:
What was
the addy in st. pete, i live here and I'm a mailman, i might be able to
find out a little something.
J.R.
Frank Cummings
3044 9th Ave N.
St. Petersburg, FL 33713
I just finished that exact job on a 64 Skylark. From the kit I used the
three floor panels and the tank braces. The body braces were in great shape so I
did not disturb them. You will have to make some choices as to where you will
cut and fit your panels. Where you have bad and good metal to
I had to make a few tweaks, but yes I think you will be right at 350 HP
and 400 lb-ft torque. I used Dyno2000 and was able to set the engine to
355, 10.5:1, Summit-1104 cam, increased lift to 0.496", selected a dual
plane manifold, 600CFM carburetor, small tube headers with mufflers, and
I had to
i'm currently getting the same thing done on my
65. they are correct it is a 7 piece set. you can find them just
about everywhere, so you can be picky when looking at the prices. i've
found most my metal through NPD or goodmark to be the best prices so
far.
J.R.
65 Malibu SS Convt #'s
7
Med Vennlig Hilsen/Kind Regards/Cordiali Saluti
André Broe Jensen
Would someone be so kind to run my combo on their desktop dyno
355 cid
10,5 compression
Summit 282deg cam.
Intake & Exhaust duration 224deg at 0,50
Intake & Exhaust lift 0,496 with 1,6 ratio rockers
Camel humps 292 Heads
What was the addy in st. pete, i live here and I'm
a mailman, i might be able to find out a little something.
J.R.
Hi Phil
Tom pointed out there
are 7 pieces to the total set. three trunk floor sections, two side body braces
and the two trunk floor brace/fuel tank mounts.
It's a DIY if you have the
tool.. welder,air body saw ect.
There are a few different
floors on the market some only go up the
7 matches
Mail list logo