For more information;
http://www.cisco.com/warp/public/129/bri_invalid_spid.html
regards
/Stuart
-Original Message-
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of
MADMAN
Sent: 18 February 2003 15:06
To: [EMAIL PROTECTED]
Subject: Re: Isdn error with PPP - Why always?? [7
Hello,
a standard ethernet link is 10Mb/sec
ie
10Mb/s = 1000 bits/sec (/8)= 125bytes/sec = 1250K/sec = 1.25MB/sec
dont get confused between Megabits (Mb)and Megabytes (MB) ;)
I hope this helps
regards
/Stuart
-Original Message-
From: [EMAIL PROTECTED] [mailto:nobody@;
Best practice for speed at which b channels come up is the following
dialer load-threshold 2 (dont use 1, there are a few issues, 2 = .78%)
load-interval 30 (defualt is 5 minutes, this is the a moveing weighted
average at which load is calculated)
also to bring up b channels v.fast configure
.
-
| | Stuart Potts
||| ||| Customer Support Engineer
.|. .|.
.:|:.:|:.
c i s c o S y s t e m s Email: [EMAIL PROTECTED]
"Empowering the Internet Gener
down space.
Other than that as Cyndi mentioned use another term application.
/Stuart
-
| | Stuart Potts
||| ||| Customer Support Engineer
HI,
Not really on a router, well you can to a certain degree by filtering ip
address using access lists, but this is not really a solution and to be
honest quite course grained, when what we are after is finer granularity
which a router can not provide
I.e. if mail programs use smtp then this is
vlan 2
ip add 10.2.1.1 255.255.0.0
etc
on thr switch
int fax/x
switchport mode trunk
and thats pretty much it.
Kind regards
/Stuart
-
| | Stuart Potts
level by using the following command:
set logging level sys 3
Regards,
/Stuart
-
| | Stuart Potts
||| ||| Customer Support Engineer
Thats right,
cisco hdlc is not compatible with other vendors implemenation of hdlc.
An HDLC frame format is shown below:
111 2 variable
2 1
+++++---++--
--+
|flag|addr|c
Cisco ATM Solutions. by cisco press
-Original Message-
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of
Boomie Okeowo
Sent: Friday, February 09, 2001 1:44 PM
To: [EMAIL PROTECTED]
Subject: ATM BOOK
Can anyone recommend a very good ATM book, please.
-B
___
Hi,
As long as you don't have any L2 loops then your fine, it will be a more
stable topology but only as long as you know there aren't any loops going
on.
On your 3500xl you can further improve this by enabling portfast on the
switch ports connected to PC workstations, ( this eliminates the produ
All.
Actually the 2948G is based on the 4000 series switch which is a fix config.
48 10/100 ports plus 2 1000 baseX ports, architectural wise is has 2
non-blocking gig and 6 ASTRODOME thus only 8 of the 12 pipe from the K1 chip
are used.
-Stuart.
-Original Message-
From: [EMAIL PROTEC
12 matches
Mail list logo