Are you intending to use serial 0 and 1 as the switched ports? if so you
have a config error in that S1 points to S3 not S0. I know of no reason you
cannot put a clockrate command on S0 as well, is that the problem you are
having? I think you also need to set the LMI type for IOS 11.1
Neil
I was moving the cable around between ports attempting to get the serial
interfaces to stay up. I forgot about the LMI configuration on 11.1. I'm
upgrading to 12.X tomorrow then I'll try again.
Thanks
Mike B.
""Neil Schneider"" [EMAIL PROTECTED] wrote in message
998v5d$hh9$[EMAIL
Make sure the cable you are using a cable with the DCE end plugged in to the
serial port. You cannot set the clock rate if the cable has the DTE end
plugged in to the Serial port.
Use the command: show controllers
Louie
-Original Message-
From: [EMAIL PROTECTED] [mailto:[EMAIL
I hope you meant
int ser0
clockrate 56000
and that you added
int ser3
frame-relay route 301 interface Serial1 101
clockrate 56000
-e-
mtxpert [EMAIL PROTECTED] wrote in message
998tg6$8l4$[EMAIL PROTECTED]">news:998tg6$8l4$[EMAIL PROTECTED]...
I have a Cisco 4000 I just received and I can't
4 matches
Mail list logo