I just set this up on a 6506 with two MSFCs running HSRP.
MLS is on by default at the switch layer but you still need to define it for
each router interface.
See the Cisco documentation for this at the following URL:
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_5_4/msfc/mls.
PROTECTED];
[EMAIL PROTECTED]
Sent: Tuesday, June 06, 2000 3:28 PM
Subject: Re: 6506 Vlan and layer 3 switching
question
I understood, you have to configure mls rp for the
mulitlayer swithing to work, right? why you do not
need mls rp when using MSFC? Is that because the
RSM
is on board, i
/univercd/cc/td/doc/product/lan/cat6000/sw_5_3/msfc/mls.
htm
- Original Message -
From: "Kent" [EMAIL PROTECTED]
To: "Michael Rasmussen" [EMAIL PROTECTED]; [EMAIL PROTECTED]
Sent: Tuesday, June 06, 2000 3:28 PM
Subject: Re: 6506 Vlan and layer 3 switching question
I
You shouldn't have to do anything else to route
between just those two VLANs. Also just a side note. The mls rp ip
command is not necessary since you are using the MSFC.
""Josh Youngman"" [EMAIL PROTECTED]
wrote in message 002801bfcf35$c2e0$[EMAIL
4 matches
Mail list logo
