On 02/15/2018 01:22 AM, Elisenda Cuadros wrote:
Hello Taiidan,
I bought it used, but the seller was so kind to send me the module. It
was a nice surprise.
The rare moral fleabay seller haha.
If you need high quality photos of this module or anything else,
please don´t hesitate to contact me.
Hello Taiidan,
I bought it used, but the seller was so kind to send me the module. It
was a nice surprise.
If you need high quality photos of this module or anything else, please
don´t hesitate to contact me. I will be happy to help.
My cpu is 6238 not 6328, but thank you for your advise :-
On 02/14/2018 06:08 PM, Elisenda Cuadros wrote:
I have an ASMB4-iKVM. I think it's this, although it has two stickers
and I can not see the concrete model
If you got your D16 new it comes with one (so that is probably what you
have) - its a tiny little module that attaches next to the PCI-e slo
Ok, thank you for the clarification.
I thought the connector was needed to program the module.
I have an ASMB4-iKVM. I think it's this, although it has two stickers
and I can not see the concrete model
Ok.. flashing is done with your flashrom version. Sorry for not reading
the whole instruct
-BEGIN PGP SIGNED MESSAGE-
Hash: SHA1
To try the OpenBMC port you don't need to solder anything; you just need
to find an ASMB4-iKVM module and program it. Soldering is for if you
want access to the JTAG connector for low-level development (U-Boot
development, mostly).
https://www.asus.c
Yes, I cleaned the CPU before but it's obvious it wasn't shiny :-) .
I want to try your OpenBMC port. I readed I have to solder the 20 pin
connector.
Pin 1 is the squared shape, isn't it? But which is Pin 1 in the female
connector?
Best regards,
- Eli
On 14/02/18 23:42, Timothy Pearson w
-BEGIN PGP SIGNED MESSAGE-
Hash: SHA1
Good to hear. I was going to mention bad CPU but that seemed unlikely;
on this end we always make sure the CPU contacts are shiny before
attempting boot so that could explain the discrepancy.
On 02/14/2018 04:38 PM, Elisenda Cuadros wrote:
> Thank yo
Thank you for your reply Timothy.
I removed the heatsink and cleaned the cpu contacts.
Now it boots.
Thank you for your support.
Best regards,
- Eli
On 14/02/18 22:46, Timothy Pearson wrote:
-BEGIN PGP SIGNED MESSAGE-
Hash: SHA1
Dead / incompatible DIMM, DIMM(s) in wrong slots, or
-BEGIN PGP SIGNED MESSAGE-
Hash: SHA1
Dead / incompatible DIMM, DIMM(s) in wrong slots, or damaged mainboard.
The fact that the vendor BIOS won't post is a very bad sign, since in
our experience the vendor BIOS is far more forgiving of faulty DIMMs
than coreboot (basically, the vendor BIO
Hello,
I recently bought an Asus KGPE-D16 board, with an Opteron 6238 and 4
Micron MT18JSF25672PDZ-1G4F1DD modules.
Firstly I tried to boot with vendor BIOS but I don't get any output on VGA.
I have a PCI Post Card and it seems it arrives to 3E and then I think it
enters in a loop.
I flash
10 matches
Mail list logo