2 things
1 LMS 7.7 is ancient. Install 7.9.2.xxx
2 If the host is Windows then consider Plex for photos & movies
VB2.4[/B] STORAGE *QNAP TS419P (NFS)
[B]Living Room* - Joggler & SB3 -> Onkyo TS606 -> Celestion F20s
*Office* - Pi3+Sreen -> Sony TAFE320 -> Celestion F10s / Pi2+DAC & SB3
->
Greg Erskine wrote:
> Have you had a play with the CPU Governors on the [Tweaks] page?
>
> By default, pCP uses ondemand.
I haven't - didn't even think to look there!
Plenty more there to investigate, thank you. I think the 'Powersave'
option will do the same as I did when I set 600MHz, but
Have you had a play with the CPU Governors on the [Tweaks] page?
By default, pCP uses ondemand.
Greg Erskine's Profile: http://forums.slimdevices.com/member.php?userid=7403
View this thread:
Paul Webster wrote:
> OP is 125 CA $ cheaper than the other with transnav knob ... but is
> used.
> Will be a good measure of value preservation.
Exactly. I have done my research here and have seen both those postings
and any others I could find.
I believe I'm asking for a fair price, and
chill wrote:
> Underclocking seems to make remarkably little difference in my setup -
> perhaps 3 degrees under load.
Actually, LMS isn't really much of a load. So I ran some consecutive
oggenc jobs while LMS was rescanning. Whereas this would have taken the
temperature into the low 70s, it
Underclocking seems to make remarkably little difference in my setup -
perhaps 3 degrees under load. I don't think my setup is completely
representative though, because my Pi lives inside my amplifier, where
the ambient temperature is higher than normal. So I set it the task of
a clear and
chill wrote:
> There seems to be a fair amount of resistance to using the Pi4 for LMS,
> based on heat issues, and reports seem to suggest that in an enclosed
> case with no airflow it can run very hot. I should stress that in my
> application, with a 40mm heatsink and a bit of convection
There seems to be a fair amount of resistance to using the Pi4 for LMS,
based on heat issues, and reports seem to suggest that in an enclosed
case with no airflow it can run very hot. I should stress that in my
application, with a 40mm heatsink and a bit of convection airflow,
running LMS and