[EMAIL PROTECTED] writes:
Appreciate any recommendations. thanks Wade
I'd use contact adhesive. Hair dryer would get it back off in the future if
I had to.
**It's Tax Time! Get tips, forms and advice on AOL Money &
Finance. (http://money.aol.com/tax?NCID=aolcmp00300
"Jim Shorney" <[EMAIL PROTECTED]> made an utterance to the drakelist gang
--
Construction adhesive.
It will never come off again.
73
-Jim
--
Ham Radio NU0C
TR7/RV7, TR6/RV6, T4XC/R4C, L4B, NCL2000, SB104A, R390A, GT550A/RV55
john <[EMAIL PROTECTED]> made an utterance to the drakelist gang
--
Or a couple dabs of rubber cement...
John K5MO
At 03:47 PM 4/12/2008, you wrote:
Hi Wade,
A thin application of silicone sealant betwixt the two surfaces sh
A few small dabs of hot glue will work also, dries fast & not much needed.
73...
Rich WA2RQY
PS- i've used double sided tape also, eh, ok!
**
It's Tax Time! Get
tips, forms and advice on AOL Money & Finance.
(http://money.aol.com/tax?NCID=aolcmp0030002850)
[EMAIL PROTECTED] made an utterance to the drakelist gang
--
I'd use epoxy in the center and RTV around the edge, but not close to it so
it doesn't flow outside the edges of the logo plate.**It's Tax
Time! Get tips,
3:47 PM
To: [EMAIL PROTECTED]
Subject: Re: [drakelist] Re-attaching Drake MS-4 Logo to Speaker Grill
Hi Wade,
A thin application of silicone sealant betwixt the two surfaces should do
the job A-OK, and THEN some...
~73!~ Eddy VE3CUI -
, 2008 3:29 PM
Subject: [drakelist] Re-attaching Drake MS-4 Logo to Speaker Grill
Hi Drakelist
Does anyone have any suggestions on the best way to re-attach the Drake MS-4
Logo to the speaker grill? The original backing was a form of adhesive which
has dried out over the years. I was
Hi Drakelist
Does anyone have any suggestions on the best way to re-attach the Drake MS-4
Logo to the speaker grill? The original backing was a form of adhesive which
has dried out over the years. I was thinking about the following
alternatives:
(1) Double sided tape - might leave a gap betwe
8 matches
Mail list logo
