Good Evening,
Yesterday began sunny, then the temperature dropped and a layer of
clouds formed below me. They created a dense ground fog when they
rose. Later I saw a swirl in the mist as a head popped out. A doe was
feeding, then scanning the surroundings. Her head would drop into the
I've built one too. It works great. https://sm7iun.se/station/ic705/
Björn SM7IUN
Den lör 16 okt. 2021 kl 04:23 skrev Greg Mitchell :
> Not an elecraft, but an option:
>
> https://qrper.com/2020/11/curt-builds-an-icom-ic-705-control-interface-for-his-elecraft-t1-atu/
>
> On Fri, Oct 15, 2021 at
From the firmware release notes:
* K3EXREF USERS MUST NOW ENABLE THE MODULE IN THE MENU: To do this,
locate the CONFIG:REF CAL menu entry and tap 2 to change the setting;
flashes XREF IN or XREFOUT. If you DO NOT have a K3EXREF module
installed, use the XREFOUT setting (the default). If you
Greetings all,
Is there a way to match the encoder speed between the KPod and the K3? The KPod
adjusts the VFO half as much as the K3 (SN18xx) per revolution of the dial.
Tnx,Jim, W5QM
__
Elecraft mailing list
Home:
Hi,
I have NR turned on on my KX3. When I do an ATU TUNE, "NR" stays on the
display, but the noise reduction isn't actually happening. If I turn NR off
and on again, it works again.
Known bug?
73,
Julie
__
Elecraft mailing list
Home:
Hello K3 List
Asc mentioned, I had my K3 re-worked to bring it totally up today, including
630m.
After some help help from here, I am now operational.
So I just plugged my Leo B Precision GPS Reference Clock (dual) into the
ref-cal plug
It's set for 10-megs
It "seems" to me I "used" to see
The PTT output is an RCA jack next to the power connection. There is an
internal
MOSFET that pulls it to ground on transmit. It can sink up to 1A, and
tolerate up to
200V. It can only switch POSITIVE relay voltage. So if you have an
old tube amp
that has a negative bias/relay voltage -
I just purchased a new amp (HLA 305) and began hooking up amp. Read the
instructions in the manual and it stated that if there was no PTT, to
change the VOX setting to "on" which I did. I attempted to TX and there is
no response from the amp. I called DX Engineering and was told that the PTT
must
8 matches
Mail list logo