:
The DATA A mode is USB, but turns off RX EQ, TX EQ, and compression.
wunder
K6WRU
CM87wj
http://observer.wunderwood.org/
On Jan 5, 2015, at 1:00 PM, Gary Mohrlant w0...@arrl.net wrote:
I like to using the RX audio Equalization on my K3.
I use the K3 for some of the digital modes and when I do I
I like to using the RX audio Equalization on my K3.
I use the K3 for some of the digital modes and when I do I need to have
a flat audio response.
Is there a way to turn off the equalization when I don't want it and
then turn it on when not running digital modes.
I know I can reset it to
Jim
If I drive my KPA 500 with 10w I get 180 out on 6M
Gary W0GHZ
On 3/29/2014 14:30 PM, Jim Rogers wrote:
I am considering a K3/10 and the KPA-500. Anyone out there using
this setup and how much power can you achieve from the KPA-500 with
10W of drive or less? My goal would be 250W on
I'm assembling a KPA-500 that I received today and I'm at the step where
I mount the Rectifier bd to the Z-bracket. It looks like the 4 holes for
mounting the rectifiers should be threaded for 4-40 screws but mine has
about 1/8 holes. There is no mention of using a screw and nut to mount
them
Has anyone connected a P3 to the above rig. If so can you tell me where
you tapped off for the IF.
Thanks
Gary W0GHZ
w0...@arrl.net
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help:
I'm running ACLog3.3 and haven't had these problems. My K3 firmware is
up to date.
Gary W0GHZ
I've noticed since a few firmware updates ago that if you are using
the rig interface inside of ACLog 3.3 the logger pauses and seems to
hang for a bit waiting on something. If I turn off Rig
I'm thinking of getting a P3 and I know the Elecraft site says it works
with logging software but I'm just wondering if anyone is using N3FJP AC
log along with a P3 since they both need the RS232 port.
Gary W0GHZ
__
Elecraft mailing
Thanks to everyone who replied to my logging question.
Guess a P3 may be ordered soon
Gary W0GHZ
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post:
From the manual:
Most calibration procedures use Tech-Mode menu
entries. To enable these, set CONFIG:TECH MD
to ON. Set TECH MD to OFF afterward.
So if Tech mode is off I don't think the Tune button should not have
any effect on the Calibration.
On 11/12/2012 15:46 PM, iain
I have looked at the manual and on line and I haven't found the tuning
range of the KAT3 tuner. Anyone have this info?
Gary W0GHZ
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help:
10 matches
Mail list logo