FOR SALE:
ELECRAFT: XV-50 w/ XVOVN . $300
ELECRAFT: XV-144 w/ XVOVN . $400
Or $600 for the pair.
Excellent condition, non-smoking environment.
Reason for selling: Not required with my K3.
Contact direct: w8...@yahoo.com
__
To: All that responded.
Thanks to all of you that responded to my request for information.
Much useful information was received (simple to complex schematics) from
many respondents for auto switching PTT and TXin / TXout lines to many
Xvtrs.
I intend to proceed with one of the simpler circ
Gentlemen,
I am looking for a circuit that one of you K3 users may have designed to
automatically switch the K3 PTT line between multible external
transverters as the K3 is switched from band to band.
I presently use the K3 PTT line to key my 6m amp driven with 30 w from
my K3.
I recently
All,
I have noticed the long (several second hang time) before the P3 switches back
to RX after Xmit.I do have the XVGA board installed to drive my 20" 16x9
Monitor.I have also noticed that at times the display on the monitor is offset
from the P3 display, eg the P3 display shows signals within
I agree with Rick's comments above. I use N1MM for FSK RTTY. I have an extra RX
window set up to receive signals from VFO B in split mode so I can tell who the
last worked station was while I copy the DX with VFO A. With a narrow 400 hz
bandwidth and 10 khz span on my P3 I can easily tune from s
Help !
I just added a KPA500 to my K3, P3 setup.
I have an interface question / problem.
I connected the TX keying line connector to my K3, then the Y cable,
then the AUX cable to my KPA500. I am using the key out from the K3 to
the PA key jack on the KPA500. (All per Elecraft Manual). This s
6 matches
Mail list logo