I use the mouse left-handed. There should be a setting to swap left and right
mouse buttons.
73
Lui, DL6FBR
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post:
Hi Andi,
I couldn't increase the output power. For every tested mode it was set to 100 W.
The reading of the cross-needle SWR & Power Meter in the video is a bit
misleading.
73,
Lui
On 30.01.2022 05:53, elecraft-requ...@mailman.qth.net wrote:
For each of the cases that gives misleading 1:1
I have installed the production release R28.
My K4 (serial # 0223) has a built-in KAT4.
In early September 2021 I reported an issue with the
SWR bargraph display of my K4 to Elecraft support.
In some modes the SWR always shows 1:1 although
the real SWR is 1:2 or higher.
Rob from Elecraft
Thanks Julie. It's a bit my fault. I've choosed a new thread
since it's a new question. So I should have mentioned the K4
again. I think my question/observation should be clear now.
On 09.09.2021 22:56, Julia Tuttle wrote:
Mike's message was a tongue in cheek response to (part of) Ludwig's
Hi again (and thanks for the "R"/"DR" explanation).
Here is an observation with the noice reduction NR.
The bands are quite noisy here. So I use NR ADJUST
set to 4 or 5.
- When I last used the 40m band, mode was LSB,
bandwidth was 2.8 kHz, and NR was ON.
- Switch from some other band back to
uld write mails in plain text on this reflector.
HTML-only mails come through completely empty.
Attachments are also not allowed and will be stripped as well!
73,
Peter - PA0PJE
Op 09-09-2021 om 08:37 schreef Ludwig Hechler:
__
Elecraft
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list:
7 matches
Mail list logo