[Elecraft] KIO3B Installation Problem

I read the post that Rick N6XI wrote about the problem getting the KI03B to sync. With ports. I have the exact same problem with my K3 after I replaced a defective KI03B main board. During the time that it took for my replacement board to arrive, my computer in the shack failed. I purchased a

[Elecraft] KI03 error

On powering up my K3 I receive a KI03 error. I updated the KI03 when it was first available. What I need to know is, what is the best way to troubleshoot the problem to identify which board is affected. I know that I can buy a new set of boards but I am trying not to go that way. I would like

[Elecraft] Audio On K3 (solved)

I feel like a idiot, Ted was right upper side band had flipped to lower side band. I guess that you always miss the obvious and make things too difficult when not needed. I need to find why it happened as 15 meter also had flipped. Thanks to all who gave suggestions, I placed those on my "When

[Elecraft] Audio on K3

I powered up my K3 and discovered that the audio was very distorted. It sounds as if everyone is off frequency and no amount of tuning will clear it up. I was using 20 meter SB and it is the same on all other frequencies except 2 meter. I checked all settings that I use and nothing has changed

[Elecraft] AGC INFORMATION

I have been following the thread with regards to the setting of the AGC of the K-3 with great interest. I am new to the use of the K-3 even though I have owned the radio for some time. I had a medical issue that delayed my use of the unit.My K-3 has been updated with all of the current K-

[Elecraft] VOX SETTING FOR UPGRADED K-3

I have upgraded my K-3 with all available new K3s updates and I just received it back from Elecraft (check up and align). There is a great improvement in performance but I now notice that when I set up my Heil Proset (ic) headset for Vox use, I must run the anti-vox a lot higher than I used too

[Elecraft] Information Needed

I will be constructing a rack for my, K-3, KPA-500, KAT-500, P-3. My concern is how much air space is needed for the equipment. I need to rack the equipment to increase space on my bench. The KPA-500 will be on bottom, mainly because of the weight. The speaker in the K-3 is not a problem beca