I suffered MCU LD a couple of months ago and eventually sent the K3 back
for service. A part was replaced, hence, not a software or software
loading problem.
I know you will receive replies off-line about this. Please share those
responses.
Thanks,
Bill W2BLC
IN GOD I TRUST (but, NOT a
Igor,
It should not be necessary, but I would first connect the K3 direct to
the computer com port (eliminate the P3 from the serial port chain).
Then look at the K3 Utility help file (or the K3 manual) for Forcing a
Firmware Download. Follow those instructions to get the K3 running again.
: Don Wilhelm [mailto:w3...@embarqmail.com]
Sent: Saturday, September 15, 2012 8:40 AM
To: Igor Kosvin
Cc: elecraft@mailman.qth.net
Subject: Re: [Elecraft] [PSSVGA] Betta software messed up the K3
Igor,
It should not be necessary, but I would first connect the K3 direct to the
computer com port
After installing P3 SVGA module everything was fine. Then I decided to try
the beta software for P3. I had trouble loading it, the P3 utility would
show that one of the FPGA images will not load. After couple attempts
suddenly MCU LD appeared on K3 display and the red TX LED on K3 would blink.
No
4 matches
Mail list logo
