Thanks for looking into this Wayne. I hope my discovery helps.
Elecraft support is fantastic- and I'm continually impressed with your
active involvement in the Elecraft community. If only all companies were
run the same way, the world would be a much better place.
Cheers and 73's
-David
--
Thinking about this - perhaps with ACC2 set to Lo=PTT the unit is attempting
to transmit and notices it is "out of band" and just hangs up the
firmware??? What's strange is that this behavior does not happen until I
try the Temp Compensation routine - which you would think would only affect
the PL
Bug, now on the list.
tnx
Wayne
N6KR
On Oct 23, 2014, at 10:23 AM, David - KI4UVC wrote:
> Don,
>
> Thank you for your very informative and helpful post - this clears up quite
> a bit of how the ACC2 interfacing is taken care of.
>
> I contacted Elecraft support and was given my original sett
Don,
Thank you for your very informative and helpful post - this clears up quite
a bit of how the ACC2 interfacing is taken care of.
I contacted Elecraft support and was given my original settings (I had
neglected to save) and restored the unit to "factory fresh" status - with
the exception of ha
David,
I did not have my brain fully in gear on this situation before. The
GPIO input is just that - an input to a 3 volt logic device with only a
500 ohm series resistor. So there is nothing to make it either a high
nor a low level. In the digital world it is known as a 'floating input'
a
David,
Contact KX3support(at)elecraft.com to see if they can offer any
additional wisdom. If it has to go back to Elecraft for work, that
contact at support is the starting place to obtain an RSA.
73,
Don W3FPR
On 10/18/2014 10:53 AM, David - KI4UVC wrote:
Nothing is connected to ACC2 curre
Nothing is connected to ACC2 currently - I was mucking around with menu
settings.
I tried reverting back to MCU2.23 and am having the same issue - radio hangs
at any change in ACC2 settings.
I didn't have this issue until I did the Extended Temp Calibration routine.
Radio is in the low 6000 s/n
David,
What do you have connected to the ACC2IO jack? Is there possibly
anything there that could be holding that signal to ground?
73,
Don W3FPR
On 10/18/2014 9:27 AM, David - KI4UVC wrote:
Love my KX3 but ran into some strange behavior as of late with some hangs.
Running MCU 2.25 / DSP 1
Love my KX3 but ran into some strange behavior as of late with some hangs.
Running MCU 2.25 / DSP 1.30 when trying to change ACC2IO settings, when I
turn VFOA to LO=Ptt the unit hangs on the LO=Ptt option - display freezes at
LO=Ptt and I can't PWR off using ATU/BAND-.
I've tried re-flashing MCU/
9 matches
Mail list logo
