...
>BUT, the first thing I noticed in your settings list it the Microphone
>select is FP.L
Me too, but I'm a bit too late to answer!
Anyway there are other settings that 'sound strange' to me:
>>
>> When in VOX the K3 stays in transmit
>>
>> AF Gain High
>
.
At least that is what I do.
73 and good luck with the whole banana.
Milt, N5IA
-Original Message-
From: Tony McClenny
Sent: Saturday, March 16, 2013 5:50 PM
To: 'david Moes' ; elecraft@mailman.qth.net
Subject: Re: [Elecraft] Echo when transmitting
Thanks to everyone, who
On 3/16/2013 5:50 PM, Tony McClenny wrote:
Disconnected K3 input to computer soundcard and the SSB noise / echo
disappeared - now to fine tune. Thank you.
There was a time, around the time when dirt was young, that the mic had
a 1/4" phone plug on it and went to the 1/4" mic jack on the fron
PM
To: elecraft@mailman.qth.net
Subject: Re: [Elecraft] Echo when transmitting
I had a similar problem some time ago.had me baffled for a while
If your computer is connected to line in and out try disconnecting
them. If the problem disappears then check that the sound card used
for the K3 aud
I had a similar problem some time ago.had me baffled for a while
If your computer is connected to line in and out try disconnecting
them. If the problem disappears then check that the sound card used
for the K3 audio by opening recording devices, then select the device
you are using fo
Hi Tony & fellow Elecrafters,
Could be that you have your monitor level up too high, could this be the
source of your "echo" but there is virtually no latency or delay (Echo)
as with an echo.
My thoughts for what it is worth.
Eric, VK3AX, (K3 4520).
On 3/17/2013 9:52 AM, Matt Zilmer wrote:
That would be my first question too. How about checking your LINE IN
to see that there is no signal on it. If you have it connected to a
sound device, there could be non-MIC input happening, along with your
voice audio. Or you could have your own voice audio coming into the
input from both the M
Is the TX monitor turned on?
73,
Scott, N9AA
On 3/16/13 3:52 PM, Tony McClenny wrote:
Ideas to correct the following would be appreciated - thank you in advance.
This is something new and I am perplexed.
I am using a Heil Pro-Set Plus microphone/headphones (with elements HC4 &
HC5). The
Ideas to correct the following would be appreciated - thank you in advance.
This is something new and I am perplexed.
I am using a Heil Pro-Set Plus microphone/headphones (with elements HC4 &
HC5). The microphone line is connected to rear of K3 in the "Mono" jack.
The Heil headphone 1/8" stere
9 matches
Mail list logo