Have you followed the instructions in the microHAM USB Interface III
Users Manual to set the jumpers for the correct serial signal levels
(RS-232 in this case)?
After that, look at the configuration example for USB III and N1MM
Logger+ which is available in Router (Help | Download Documents) or
The router software should show if the K3 is connected. Make sure that
this works before opening the logging software. Like others have said, use
38400 baud. Carefully follow the MicroHAM instructions.
John KK9A
N6XI wrote:
You got good advice on baud rate. Also, it's wise always to confirm prop
Rick,
Thanks for advice on Utility. I downloaded and ran but still no joy. I did see
FW rev 05.38. I don’t know if that cud be the problem?
Greg Best
Sent from my iPhone
> On Feb 15, 2018, at 9:31 PM, Rick Tavan wrote:
>
> You got good advice on baud rate. Also, it's wise always to confirm p
You got good advice on baud rate. Also, it's wise always to confirm proper
operation with K3 Utility first. If it doesn't connect, chances are N1MM
won't, either. Utility marches through speeds until it finds one that
works. MM requires a specific speed setting.
73,
/Rick N6XI
Rick Tavan
Trucke
Yes, I believe the baud rate is the problem.
Should be 38400.
de VK2HHS
On Fri, Feb 16, 2018 at 12:57 PM, Jack Brindle wrote:
> A little more info. The K3 and K3S default to 38400 bps on the serial
> port. This can be changed in the configuration menu, and you should verify
> the setting in th
A little more info. The K3 and K3S default to 38400 bps on the serial port.
This can be changed in the configuration menu, and you should verify the
setting in the menu system.
If it is still set to the default, set your PC for 38400 bps (and the MicroHam
device as well, then give it a try. N1MM
Try 38400 instead of 4800.
Jack, W6FB
> On Feb 15, 2018, at 5:33 PM, Greg Best wrote:
>
> I am trying to get N1MM+ to talk to my K3 but will not do it.
>
> I am setup for 4800 B, Data 8 bits, Parity N, stop bits 1. DTR and DTS have
> been tried with both Always ON and Always OFF but neither
I am trying to get N1MM+ to talk to my K3 but will not do it.
I am setup for 4800 B, Data 8 bits, Parity N, stop bits 1. DTR and DTS have
been tried with both Always ON and Always OFF but neither one works.
I have tried the Radio reset command from N1MM+ with no luck.
Can anyone help?
73¹s
Greg
8 matches
Mail list logo
