I am using the same mike with the kenwood cable on my K-2. Since it is
basically the same Heil mike that was made for the K2 but is no longer
available- I used the settings (jumpers) as described for the Elecraft MH-2
in the manual for the KSB2. To include the 5.6 K resistor from pin 1 to pin
6.
I am finishing up K2 #5113 and have run into a snag configuring the
microphone on the K2SB2. I am using a Heil Handi Mic HM-IC. Bob Heil
told me to get this mic as he said it would optimize my 706 MKIIG and
the K2. I'm using the Kenwood 8 pin cable for the K2, again per Heil's
recommendation.
Jonathan,
At best we can but guess that your mic (or the K2 mic configuration header)
is not connected as you expect - did you add the resistor on the back of the
mic jack or the mic configuration header to support the use of the Electret
element (since this is an ICOM type mic based on the -IC
3 matches
Mail list logo
