Jeremy,
Yes, an RF probe would be useful to evaluate the health of the crystal
for 40 meters.
Since those crystals are reliable, I suspect that you have a problem
with the Pre-Mixer Bandpass Filter.
You need to have at least 200mV peak to peak signal (70 mV measured with
an RF Probe) to prov
Hello,
I recently finished the receiver portion of my K1 (40m/20m). I successfully
aligned the 20m filters, but on 40m there is very little noise, and the noise
does not change when there is an antenna connected. However, I have received
some very nice signals on 20m.
I have inspected the
Check to be sure that you have set the correct 30-meter band edge (10.0
or 10.1, depending on your chosen VFO range). See the manual's
instructions for setting the Bx parameters.
Some years ago I had a problem similar to your first one. It turned
out to be a defective pair of relay contacts on m
I have a K1 with the 4 band filter board (40,30,20,15). I recently removed this
board and tested a two filter board (80,17) that had come with this radio. The
second board worked fine but the problem I have is that when I replaced the
original filter board and reconfigured the band settings, som
4 matches
Mail list logo