Peter,
One easy check is to make sure all relay pins are soldered. It is easy
to miss one, especially near one of the board vias (empty through-holes0
and a missed coil pin gives you a 50% chance of having the relay stuck
such that an extra L or C is on the at all times.
Others will respond wi
Peter,
Yes, the KAT2 can be nulled without removing R6, and yes, obtaining a
minimum reading of 10 or 11 is quite normal.
The reason for initially having R6 not installed has to do with checking
for shorts - but since the manual calls for a specific voltage range for
the check, the null proc
According to the manual, it should be possible to adjust the null to
000, and it should be a broad null. On mine, it was extremely sharp,
and wouldn't get lower than 010, flickering to 011. Does this indicate
a problem? I went ahead and finished the installation -- the voltages
were fine, and th
3 matches
Mail list logo
