Hi -
I'm in the process of building my K2. I've completed the control board, and am
performing the resistance checks as recommended in the manual. All check out
OK except for the test for pins 29 and 30 of U6 (the dash and dot/ptt pins).
The resistance values as stated in the manual are
Dan,
In this particular case, a little high is not a problem - low might be
problematic.
Normally if a single value is listed for a resistance check, allow a +/-
10% tolerance, but when a range is listed, normally the readings you
obtain should fall within the listed range.
73,
Don W3FPR
2 matches
Mail list logo