December 03, 2012 9:31 AM
> > To: Dick Dievendorff
> > Cc: elecraft
> > Subject: Re: [Elecraft] K3 Firmware upload elapsed time
> >
> > Yes, the uploads have been faster before.Now I will try with regular
> > usb to
> > serial cable which
> > I had kept asid
ick Dievendorff
> Cc: elecraft
> Subject: Re: [Elecraft] K3 Firmware upload elapsed time
>
> Yes, the uploads have been faster before.Now I will try with regular
> usb to
> serial cable which
> I had kept aside as I wanted FSK. Now I will take the cable directly
to
> K3
&g
Yes, the uploads have been faster before.Now I will try with regular usb to
serial cable which
I had kept aside as I wanted FSK. Now I will take the cable directly to K3
instead of via P3.
I have no other PC.
Will report back.
73 de Nandu
On Mon, Dec 3, 2012 at 9:41 PM, Dick Dievendorff wrote:
>
Has that serial path worked more quickly in the past? Do you have alternatives
available to try? That load time is terrible v
Dick
On Dec 3, 2012, at 7:56 AM, Nand Kishore wrote:
> Hi Dick,
> I have been battling with an ERR TXG problem. I am in touch with support.Have
> changed LPA.
> No i
Hi Dick,
I have been battling with an ERR TXG problem. I am in touch with
support.Have changed LPA.
No improvement in out put power,cannot exceed 10w with KPA3 in line.About
0.6W with KPA3
bypassed.Various voltages taken with rf probe as advised reported back to
support.Was advised
to do ref cal ag
About five to eight minutes is normal. You may have many retries, indicating a
less than ideal RS-232 connection. Use the view menu, verbose settings for
explicit indications of each retry. Check that your cable hold down screws are
snug. Try the troubleshooting steps in K3 Utility Help for USB
Try turning on Advanced Mode in the View menu. If the link is causing
errors, they'll be annunciated on the Send MCU Firmware pane. You
should see the progress bar marking a new block of code every few
seconds.
73,
matt W6NIA
On Mon, 03 Dec 2012 19:32:42 +0530, you wrote:
>Handshake between K3
Check the bitrate between your computer and the K3. Unless there are
problems, it should run at 38kbits/S. That's when it takes just a few
minutes, but you may have yours set to a very slow speed.
HTH
73 Dave G3TJP
__
Elecraft m
No, that's not normal. It should only take a few minutes.
Dave, N4QS
Sent via BlackBerry by AT&T
-Original Message-
From: Nand Kishore
Sender: elecraft-boun...@mailman.qth.net
Date: Mon, 3 Dec 2012 18:51:44
To: elecraft
Subject: [Elecraft] K3 Firmware upload elapsed time
Wh
9 matches
Mail list logo