Hey Gang!
I finished my K1 this evening! All seemed well until I went to install the ATU
(KAT1).
During initial test (p.9), I put the ATU mode into F1.3 and then exit out. I
press WPM- WPM+ to tune and the display reads P2.3 instead of the r8.5 that's
expected. In the troubleshooting,
Andy,
That trace cut was not to be done on a new K1 RF board. You will have
to remove the resistors and capacitor and repair the trace cut with a
jumper wire. Check page 7 - the i in a triangle informational item
near the bottom of the page - it says to skip the next 5 steps if your
board
Subject: Re: [Elecraft] KAT1 Install Troubles
Andy,
That trace cut was not to be done on a new K1 RF board. You will have to
remove the resistors and capacitor and repair the trace cut with a jumper
wire. Check page 7 - the i in a triangle informational item near the
bottom of the page
3 matches
Mail list logo
