Hello Lou,
Thanks for the helpful information!
Richard, AI4SH
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list h
There was a discussion of this topic on the KX3 group. The dot and dash
paddles (pins 3 and 4) need to make contact with ground (pin 1). The
original version of the KXPD3 had a design flaw on the circuit board which
followed the diagram in the published KXPD3 schematic dated March 2012. This
versi
It is for unspecified possible future use.
73,
Lyle KK7P
> ...Why is source 3V3D connected to Pin 3 of the KXPD3?
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Pos
Hello,
Why is source 3V3D connected to Pin 3 of the KXPD3?
I have made (but not yet used) an interface cable to connect external
paddles to the KXPD3 jack. The KXPD3 Schematic shows Pin 3 of the plug
grounded inside the KXPD3. However, Page 2 of 8 of the Control Panel
schematics shows 3.
4 matches
Mail list logo