There is a small variation in IF output level from the K3 for signals
that are within the passband of the K3 crystal filter. (The crystal
filter is after the IF OUT tap-off point but the input impedance of some
crystal filters can load down the signal level a little.) De-tuning the
calibration si
Tom,
The instructions are correct.
73,
Tom
Amateur Radio Operator N5GE
ARRL Lifetime Member
QCWA Lifetime Member
On Wed, 17 Aug 2011 17:30:10 -0400, "Tommy Alderman"
wrote:
>I'm sure this has been discussed before but if so, I have missed it.
>
>On page 24 of the P3 Owner's Manual, Rev. B, M
I'm sure this has been discussed before but if so, I have missed it.
On page 24 of the P3 Owner's Manual, Rev. B, March 29, 2011, under the
heading of Amplitude Calibration the forth button down, it states to set the
signal generator for 7040 kHz and the following button below says to set
the tra
3 matches
Mail list logo
