My thinking was to restore from an earlier workspace then reinstall the
IC-7300 but I will take a look at the controls first. I don't remember
making any recent changes to to the control configuration.
Russ, KG7VQ
__
Elecraft maili
Since you use DXLab I'd suggest checking Commander's "User-defined Controls"
configuration. Is there a slider for Mic gain? If so, is it configured to
"Initialize radio"?
In Commander click "Help" then select "sliders" for more info.
Andy, k3wyc
___
Why take out the 2nd radio? The problem is in the configuration of the
software on the computer.
Victor 4X6GP
On Sat, Jun 17, 2023, 06:26 Russ Edelen wrote:
> Thanks Victor, you called it. Started the K3 and it started with the
> correct mic controls. Booted the computer and started DXLab modul
Thanks Victor, you called it. Started the K3 and it started with the
correct mic controls. Booted the computer and started DXLab modules and
the mic gain reverted to 1. Now I know where to look. Will start by
removing the second radio, which installed when I sent the K3 back to
Elecraft, and go
Try this: shut down the computer, and turn the gain (etc.) to their
correct settings. Then turn the K3 off and on again. Do the settings
reset? If so, the problem is in the K3. If not, it has something to do
with the computer and the program.
73,
Victor, 4X6GP
Rehovot, Israel
Formerly K2VCO
CW
Some further info. Logging and control is via DXlab suite set up per the
wiki through a serial port. The controls respond in both directions and
the radio functions as expected during nets and general operation after
the mic settings are adjusted. The problem only occurs at startup. The
k3 and
I forgot to add --
It's also possible (probable?) that your computer program is doing it.
Plug in a key or mic and try transmitting without the computer connected.
73,
Victor, 4X6GP
Rehovot, Israel
Formerly K2VCO
CWops no. 5
http://www.qsl.net/k2vco/
On 16/06/2023 16:46, Russ Edelen wrote:
Aft
You can determine if it's caused by RFI very easily. Try transmitting
into a dummy load.
73,
Victor, 4X6GP
Rehovot, Israel
Formerly K2VCO
CWops no. 5
http://www.qsl.net/k2vco/
On 16/06/2023 16:46, Russ Edelen wrote:
After returning from Elecraft for repair and updating my K3 (1087) will
reset
After returning from Elecraft for repair and updating my K3 (1087) will
reset it's Mic gain to 1 and Compression to zero.
I backed up the radio's configuration when I get it back and reloading
it does not solve the problem, which occurs at boot up more times then not.
This is a barefoot setup
9 matches
Mail list logo