HI
Is this possible?
For example, can I connect a 7i77 + 7i74 to a 7i80HD using a special cable?
I see there is a converter board on Mesa's website, but I only realised now
that I messed u when ordering, and also the 7i80DB's were out of stock.
For this case, can I just refer to the pinout config
Being used to servos the first thing I test is the estop. Saves damage
to expensive mechanics.
Once I was testing a new interface. Running it from lower left to upper
right. It was gaining about .1" every pass. ... after about 4 passes it
took off for the upper corner at full speed: 400 ipm. My
On Sun, 1 May 2022 at 15:53, Alan Condit wrote:
> I was machining a part on my X2 Minimill. Suddenly it left the programmed
> track (spoiled the part)
How? It is almost impossible for a fault to cause extra steps. Does it
appear that one axis simply stopped moving?
--
atp
"A motorcycle is a b
There is a good chance there was a wiring error in you original setup. The
fact the E-stop did not work tells me there was a design error. E-Stop
should never fail, or rather if it does fail, the machine stops. If the
inputs on the drivers are blown, that says the same thing. Smaething was
wron
Hi Guys,
I was machining a part on my X2 Minimill. Suddenly it left the programmed track
(spoiled the part) and didn’t respond to Estop. I powered the system off
manually raised the Z axis and tried turning it on so I could home it, smoke
started coming from the controller. So I powered everyth
