> I am rebuilding a box with xubuntu 10.04 and the linuxcnc 2.5.4 install
> script. I ran into a similar problem last April that Sebastian walked me
> through. Rechecking those posts, the problem is a little different. While
> linuxcnc installed fine, I do not see the hostmot2 drivers in synaptic.
On 10/7/15 8:12 PM, Eric H. Johnson wrote:
> I am rebuilding a box with xubuntu 10.04 and the linuxcnc 2.5.4 install
> script. I ran into a similar problem last April that Sebastian walked me
> through. Rechecking those posts, the problem is a little different. While
> linuxcnc installed fine, I
Sebastian,
I was trying to do a quick rebuild of an old machine where the ssd died and
wanted to be able to use the existing configuration as is. I went ahead,
however and just finished installing lcnc 2.7 to xubuntu 12.04 from the
instructions here:
On 10/8/15 9:57 AM, Eric H. Johnson wrote:
> Sebastian,
>
> I was trying to do a quick rebuild of an old machine where the ssd died and
> wanted to be able to use the existing configuration as is. I went ahead,
> however and just finished installing lcnc 2.7 to xubuntu 12.04 from the
>
Sebastian,
I am building from packages. That makes sense, I did do a reboot after rtai
was installed, but not after lcnc.
Thanks,
Eric
Are you building linuxcnc itself from source or installing the debian
package?
The updated memlock limit comes from the linuxcnc debian package, not from
the
Hi all,
I am rebuilding a box with xubuntu 10.04 and the linuxcnc 2.5.4 install
script. I ran into a similar problem last April that Sebastian walked me
through. Rechecking those posts, the problem is a little different. While
linuxcnc installed fine, I do not see the hostmot2 drivers in
