: Saturday, May 17, 2008 3:17 PM
To: Enhanced Machine Controller (EMC)
Subject: Re: [Emc-users] Z-Axis Drifting Problem
On Sat, May 17, 2008 at 02:33:04PM -0500, Ray Henry wrote:
> I can't see how electrical interference would cause bad counting in
> one direction only but you might make c
On Sat, May 17, 2008 at 02:33:04PM -0500, Ray Henry wrote:
> I can't see how electrical interference would cause bad counting in one
> direction only but you might make certain your encoder cables are
> grounded at the drive end only.
I agree this sounds a bit strange, but I've seen this on two oc
Hi Nasir
Good to hear from you again. You started using EMC a long time ago.
Six+ years ago at least.
Does it do the same sort of sliding down when the moves are fast as
opposed to slow?
Is it possible that you have mechanical slip between the axis and the
feedback. If this is a motor with
Dear All,
We have installed Motenc-Lite on two milling machines.
X and Y axis on both machines show good repeatability and show no errors
after long run.
Z-axis shifts conitinously by repeated motion of 100mm for 400 times, the
error shifts the
Z-axis approximmately 1.00mm into the
