RE: tx driver

Hi! > 1) ``pciconf -l'' and ``ifconfig tx0'' output, please Both are attached. > 2) Could you upgrade to 4.4 or later? There were few changes. > Particullary, the true AC101 PHY support. You may try to fetch miibus.ko > and if_tx.ko binaries from 4.4 system, if you don't want to upgrade whole >

RE: tx driver

Hi! Sorry, for late intervention... Your dmesg shows that this is SMC9432TX_1 card, and I've never hold such one in heands :( Though I saw the SMC9432FTX, and it use the same PHY. So: 1) ``pciconf -l'' and ``ifconfig tx0'' output, please 2) Could you upgrade to 4.4 or later? There were few cha

RE: tx driver problem.

> Try doubling maxusers. Its easy, and it might make a difference. Done - but got no reasonable result :-( > after or while the problem is happening, try a 'netstat -m' It's quite long-lasting (this state takes several minutes till cvs co finishes - though it should be done in say 20 seconds

RE: tx driver

> You should send a kernel config to the list. > It might be mbuf starvtion, but that doesn't sound like a driver > specific problem. OK. dmesg from boot -v and kernel config is in the attachement. Thanks, Petr

RE: tx driver

half or full duplex > > Add one of > -mediaopt full-duplex > or > -mediaopt half-duplex > > depending on the setting of your switch to your ifconfig line in /etc/rc.conf > > This is the single most common cause of really low ethernet performance. > I ha

Re: tx driver

Hi, On Tue, 18 Dec 2001, Petr Holub wrote: > Hi all! > > I've encountered really awful behavior of my SMC card using > tx driver in FreeBSD 4.3. On 100 Mbps network I get the throughput > just about 200 kBps :-( Colleagues of mine running some PC > based routers have v

tx driver

Hi all! I've encountered really awful behavior of my SMC card using tx driver in FreeBSD 4.3. On 100 Mbps network I get the throughput just about 200 kBps :-( Colleagues of mine running some PC based routers have very similar experiences with this driver (in both 4.3 and 4.4 Rel's) The