Great idea!
On Thu, Mar 30, 2023, 5:28 PM Eric Gantner
wrote:
> Seem like a great idea! Looking forward to reading more of the results.
>
> Eric Gantner
>
> On Thu, Mar 30, 2023 at 12:52 AM 'Curt George' via Legacy Ornamental Mills
> wrote:
>
>> Hello everyone.
>>
>> I have been playing around
Seem like a great idea! Looking forward to reading more of the results.
Eric Gantner
On Thu, Mar 30, 2023 at 12:52 AM 'Curt George' via Legacy Ornamental Mills <
legacy-ornamental-mills@googlegroups.com> wrote:
> Hello everyone.
>
> I have been playing around with this idea for many years, but
On 2023-03-30 22:02, Tim Ziegler wrote:
Hey Curt,
Super excited to see your results on this endeavor. My only concern
would be and its like everything else,
the change over has to be easy and not require everything to be
realigned again.
I think it will be great though for all the small turnings
Well its great to see a couple on board for sure. I do think it will open
possibilities for sure.
Kind Regards,
Timothy J. Ziegler
Ziegler WoodWork & Specialty
14171 160th Ave.
Foreston MN 56330
320-294-5798 shop
320-630-2243 cell
On Thu, Mar 30, 2023 at 8:36 AM Dan Krager wrote:
> CAG, meth
For sure. All sounds good to me.
On Thu, Mar 30, 2023, 7:53 AM 'Curt George' via Legacy Ornamental Mills <
legacy-ornamental-mills@googlegroups.com> wrote:
> Hello and Good morning guys.
>
> Tim, The change over could not be more simple.
> On my 1000ex, There is two shaft couplers that hold the a
CAG, methinks it's a GREAT idea, as I've said before. It's something I
think I want to do, because I've puzzled how to make the REVO cut threaded
dowels of various sizes and pitch. I think it was Bill showed how to do big
screws, and that's great for many things, but the wider the pitch range,
Hello and Good morning guys.
Tim, The change over could not be more simple.On my 1000ex, There is two shaft
couplers that hold the acme screw on the machine.On the 200 there is only one
on the headstock side, and the screw has been turned/machined on the tail stock
side, to fit into a support b
Hey Curt,
Super excited to see your results on this endeavor. My only concern would
be and its like everything else,
the change over has to be easy and not require everything to be realigned
again.
I think it will be great though for all the small turnings we do in the
bone, pens and other small t